This Old Republic Sentinel armor kit is painstakingly produced from white ABS plastic, resin, and laser cut and 3D printed detail/accessory parts.
Assembly guide can be downloaded here.
* * * * * * *
FAQs:
Q) Is this armor ready to wear?
A) No. This is a build-it-yourself kit that comes as a collection of vacuum-formed parts that will need to be trimmed, assembled, and painted. The kit also contains a number of resin, foam, and 3D printed pieces that do not require trimming. The complete list of parts can be found inside the downloadable assembly guide here, or at the bottom of this page.
Q) Does the kit come with mounting hardware?
A) No. People's preferences and requirements for strapping armor vary widely. To keep costs down, mounting hardware is not included, though the Assembly Guide does provide some recommendations.
Q) Does the kit come with any soft components?
A) No. People's preferences, requirements and budgets for soft components vary widely. To keep costs down, soft pieces of the costume are not included. To see what is included in the Acolyte kit, scroll down to the “Parts List” section below.
Q) Is the helmet included?
A) No. The helmet is not included and can be commissioned separately from Mynock’s Den. Contact Mynock’s Den through the “Contact Me” section of this website, or on Etsy here.
Q) What is the height range this kit can accommodate?
A) The kit was designed to fit people between 5’6” and 6 feet with minimum modification. Shorter individuals may find it necessary to trim their pieces beyond the recommended trim lines. Taller people may experience larger gaps between armor plates (especially between the abdomen and chest plate).
Q) Is the Jedi-inspired version of the kit available?
A) The Jedi-inspired kit will be available again late summer or 2022.
Q) Will you sell individual pieces?
A) Yes, not right away, but as we get the flow of full kits going out, we'll put up individual pieces and/or parts 'sets' i.e. Arm kits, Leg kits etc.
Q) Will you be offering finished kits?
A) No. With the nature of needing to trim and fit the kit to each person like any other armor kit, it isn't cost effective for us to offer finished kits.
* * * * * * *
Parts List
Pauldron (x2)
Chest Plate (x1)
Elbow Plate (x2)
Lower Bracer (x2)
Upper Bracer (x2)
Upper Bracer Rocket (x2)
Upper Bracer/Thigh Dummy Clasps (x4)
Hand Plate (x2)
Hand Greeblie (x2)
Foam Claw (x6)
Knuckle Plate (x8)
Thumb Plate (x2)
Belt (x1)
Belt Pouch (x2)
Belt Canister (x1)
Cod Plate (x1)
Front Thigh Plate Set
Front Thigh Greeblie Set
Rear Thigh Plate Set
Shin Plate (x2)
Shin Plate Dummy Clasps (2L, 2R)
Calf Plate (x2)
Complete Foot Plate Set
* * * * * * *
Below are some photos of the Acolyte kit set up on a mannequin.
* * * * * * *